Print | Rate this content

HP StorageWorks MSL2024 Tape Library - Removing and Replacing the Magazine

Introduction

This document is provided to assist in removing and replacing the magazine for the HP StorageWorks MSL2024 Tape Library.

top

Minimum skill level

The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.

top

Tools required

  • #2 Phillips screwdriver

  • Small metal pin or paper clip

  • Ground strap

  • Electrostatic containers

  • HP Library and Tape Tools (L&TT) diagnostic software

top

Parts required

NOTE: Part numbers are subject to change.

The replacement part number will vary depending on the magazine that is being replaced. If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. Click here for more information on returning parts to HP .

Description
Part Number
Requires Return
Removable magazine - With lower left side mail slot
407354-001
No
Removable magazine - With right side mail slot
407355-001
No
NOTE: For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labelled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labelled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

top

Summary of instructions

To view a video demonstrating the procedure for removing the magazine, click on the link below. Or use the product video listing on the HP Services Media Library , then select Magazine from the menu on the upper left hand side of the screen.

Click here to view the magazine removal video (right-click on the link to open in a new window/tab).

Magazine removal

  1. Review the safety considerations before performing the steps listed below by clicking on the following link:

    Click here to view the precautions .

    CAUTION: Failure to comply with the precautions could result in damage to your product or loss of data.
    NOTE: HP recommends that you release the magazines using the operator control panel (OCP) or the Remote Management Interface (RMI). However, you can manually release the magazines if the OCP and RMI procedures fail, if both left and right magazines need to be removed, or if the magazine needs to be removed when the power to the tape library is off.
  2. Using the OCP or the RMI, release the left or right magazine.

  3. Pull the released magazine out of the library.

    NOTE: If necessary, the magazines can be released manually by inserting a small metal pin or paper clip into the appropriate release hole.
    CAUTION: Do not force the magazine removal if you encounter an unusual amount of resistance.
NOTE: The library cannot perform any operations until the magazine is replaced.

Magazine replacement

  1. If appropriate, move the tapes from the old magazine to the new magazine.

  2. Slide the magazine completely into the library.

    NOTE: The magazine will lock into place once it is correctly installed and the library will inventory the magazine.

top

Parts return

If your part requires return then click on the appropriate link below:

Click here for the defective parts return procedure for US .

Click here for the defective parts return procedure for Europe .

top

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!