Print | Rate this content

HP Color LaserJet CP2025 Series Printer - Replace the Pick Rollers for Trays 2-x

To view a video demonstrating the procedure for removing the part click here to access the Services Media Library ( Select Printers and Multifunction under the Product category , select HP Color LaserJet Printers under the Product family , and then select the printer model under the product series category.

Pick roller replacement

The roller must be rotated into the service position to remove it.

CAUTION: Avoid touching the spongy roller surface unless you are going to replace the roller. Skin oils on the roller can cause paper-pickup problems.
  1. Turn the product on, and wait for it to reach the Ready state. Perform the following steps to rotate the roller to the service position.

    NOTE: If you have removed Tray 2 to service the product, reinstall the tray before turning the product on.
    NOTE: The following steps rotate the engine paper-pickup roller and the Tray 1 paper-pickup roller into the service position.
    1. Open the 2ndry Service menu by pressing the Left Arrow button and the Cancel button simultaneously.

    2. Use the arrow buttons to select Pick roller , and then press OK .

      Press OK again to confirm that you want the roller to rotate.

    3. Listen for the roller to rotate. When the roller is done rotating, unplug the power cord, and then place the power switch in the off position.

      CAUTION: It is important to place the power switch in the off position after unplugging the power cord so that the product power does not come on immediately when the power cord is plugged in again.
    4. Remove Tray 2.

    5. Perform the remaining steps in this procedure to remove the roller. After replacing the roller, plug the power cord into the product, and then use the power switch to turn the product on.

  2. Carefully raise the front of the product.

    WARNING: Do not place the product face-up resting on the rear cover and rear door. Excess toner might enter the laser/scanner assembly and contaminate the mirrors, causing print-quality problems. The laser/scanner is not a FRU. If the laser/scanner mirrors are contaminated, the entire product must be replaced.
    CAUTION: Do not lift the product by grasping the front door and Tray 2 cavity.
  3. Release the two white plastic locking tabs and remove the pickup roller.

  4. Install the replacement roller.

    NOTE: When the replacement roller is installed, rotate the roller shaft several times to make sure that the shaft correctly engages the drive mechanism. You should hear a click when the shaft engages the drive mechanism.


Parts return

If your part requires return then click on the appropriate link below:

Click here for the defective parts return procedure for US .

Click here for the defective parts return procedure for Europe .


Provide feedback

Please rate the information on this page to help us improve our content. Thank you!