Print | Rate this content

HP LaserJet Pro 400 Printer M401 - Load the input trays

Load Tray 1

  1. Open Tray 1, and pull the tray extension away from the product.

    1: Open Tray 1

  2. For long paper, flip out the extension to help hold the paper in the tray.

    2: Flip out Tray 1 extension

  3. Place the paper stack into Tray 1, and slide the paper guides so that they are against the sheets.

    3: Load paper in Tray 1

  4. Feed the paper stack into the tray as far as it will go.

Load Tray 2

  1. Pull the tray out of the product.

  2. Slide open the paper length and width guides by pushing outward on the blue tabs.

    4: Open the paper guides

  3. To load Legal-size paper, extend the tray by pressing the release button at the back of the tray inward and pulling the back of the tray out.

    When loaded with Legal-size paper, the tray extends from the rear of the product approximately 70 mm.

    5: Load Legal-size paper

  4. Place the paper in the tray and make sure that it is flat at all four corners. Slide the paper length and width guides so that they are against the stack of paper.

    6: Place paper in the tray, and adjust the guides so they are next to the paper.

  5. Push down on the paper to make sure that the paper stack is below the paper limit tabs on the right side and rear of the tray.

    7: Make sure the paper is below the tabs on the tray

  6. Slide the tray into the product.

    8: Slide the tray into the product

Load optional Tray 3

  1. Pull the tray out of the product.

    9: Pull the tray from the product

  2. Slide open the paper length and width guides by pushing outward on the blue tabs.

    10: Adjust Tray 3 paper guides

  3. To load Legal-size paper, extend the tray by pressing the release button at the back of the tray inward and pulling the back of the tray out.

    When loaded with Legal-size paper, the tray extends from the rear of the product approximately 70 mm.

    11: Adjust the tray for legal-size paper

  4. Place the paper in the tray and make sure that it is flat at all four corners. Slide the paper length and width guides so that they are against the stack of paper.

    12: Load paper in tray

  5. Push down on the paper to make sure that the paper stack is below the paper limit tabs at the rear of the tray.

    13: Make sure the paper is below the tabs on the tray

  6. Slide the tray into the product.

    14: Close Tray 3

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!